Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Trouble Starting MZ202
#16
Hi all,
when you are applying primer, could you see fuel coming out of the air filters?
What you can try is, to put the heli higher on the side of the carbs to assure that the fuel is flowing into the engine. I use this technique with success. I always removes the right ground handle wheel first then I pump five times and after that I remove the left ground handle wheel. After the engine was started I apply some additional pump kicks to prevent it from stopping.
Mike
Reply


Messages In This Thread
Trouble Starting MZ202 - shakirhussain - 06-21-2018, 03:44 AM
RE: Trouble Starting MZ202 - Eblezien - 06-21-2018, 04:23 AM
RE: Trouble Starting MZ202 - shakirhussain - 06-21-2018, 06:11 AM
RE: Trouble Starting MZ202 - mosquito - 06-21-2018, 03:16 PM
RE: Trouble Starting MZ202 - shakirhussain - 06-21-2018, 05:03 PM
RE: Trouble Starting MZ202 - FlyGuy - 06-21-2018, 10:58 PM
RE: Trouble Starting MZ202 - shakirhussain - 06-25-2018, 06:50 AM
RE: Trouble Starting MZ202 - FlyGuy - 06-24-2018, 02:53 PM
RE: Trouble Starting MZ202 - mosquito - 06-25-2018, 02:15 PM
RE: Trouble Starting MZ202 - shakirhussain - 06-25-2018, 11:15 PM
RE: Trouble Starting MZ202 - U-L- Copter - 06-26-2018, 01:46 PM
RE: Trouble Starting MZ202 - mosquito - 06-26-2018, 02:56 PM
RE: Trouble Starting MZ202 - shakirhussain - 06-26-2018, 10:57 PM
RE: Trouble Starting MZ202 - MikeLux - 07-01-2018, 05:55 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)