Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Hirth fuel injection
#1
I have a xel with hirth 3203 engine. I want to install fuel injection but found out I need a return line installed in the tank. How hard would it be to install this return line in our tanks?
Reply
#2
It's not hard basically goes into the top of the tank -there's directions in 285 section of the manual
Reply
#3
Thank you ill look there
Reply
#4
Page A.2-17
Reply
#5
(05-09-2018, 08:38 PM)marcher07 Wrote: Page A.2-17

check with Matt at rec power he says not to put fuel injection on that engine from what i remember
Reply
#6
I talked with him he is the one that told me I needed the return line. He said was fine but expensive. Going to try the carb setup how the previous owner has it set up for now and see how it runs. Thanks
Reply
#7
(05-14-2018, 02:04 PM)Jerrod Wrote: I talked with him he is the one that told me I needed the return line. He said was fine but expensive. Going to try the carb setup how the previous owner has it set up for now and see how it runs. Thanks
my carbs setup worked great if you have any questions let me know

clumberger@aol.com
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)